Round yoke with lace leaves

Added: 27.09.2025 в 15:51 Views: 3620

The sweater is knitted from fine yarn from YarnArt JEANS BAMBOO in 50g.- 150m.

Composition: 50% - bamboo, 50% - acrylic. Color No. 102 - milky.

I knitted with 3 mm needles in one thread.

On the neckline, there is a factory set of 108 stitches.

The first two rows are knitted in hollow ribbing, and then 1x1 ribbing with crossed knits for a height of 3 cm.

Then I distributed the stitches into 18 pattern repeats and knitted the pattern according to the scheme.

I knitted the pattern to a height of 21 cm, as I have an additional repeat of leaves in the pattern. Then I knitted stockinette stitch for about 3 cm.

The height of the yoke is 23 cm.

I left 4 pattern repeats for the sleeves. On the front and back, there are 6 pattern repeats.

On the back, I knitted an Asian short row yoke for 12 rows.

And I continued to knit in the round with stockinette stitch.

Thus, I knitted 29 cm from the armhole and switched to 1x1 ribbing, which I knitted with crossed knits for 3 cm.

The stockinette stitch turned out to be loose and uneven stitches..

And on the yoke, in my opinion, there are too many leaves...

On the sleeves, I knitted 3 cm after the pattern with stockinette stitch and also finished with 1x1 ribbing of 3 cm height.

It would be enough to have leaves in three rows, but there are too many leaves on the yoke and the stockinette stitch is not quite even, so I'm unraveling the sweater.